Thingiverse
Filament Plug Guide
door JohnMion
4
Downloads
1
Likes
0
Makes
This filament guide is similar to https://www.thingiverse.com/thing:2047638 but I made it to fit a 36mm hole, as that was the size drill I happened to have in the garage...
There are ~~two~~ three versions of it:
1. The original "Filament Guide.stl" that are beveled on the upside and has got a 6mm hole in the bottom. This one is meant to be used if you have a 6mm guide tube like that which comes with the Flashforge Finder.
2. The MkII is more generic and is meant to be used without a tube. If you do not have an appropriate length guiding tube, use this one.
3. NEW! The MkIII is an updated version of the MkII with smoother bevel on each side. Note that the top bevel (facing the bed while printing) can become a little bit stringy when printing without supports. (I would still prefer to print it w/o supports and then file the artefacts away.)
There are ~~two~~ three versions of it:
1. The original "Filament Guide.stl" that are beveled on the upside and has got a 6mm hole in the bottom. This one is meant to be used if you have a 6mm guide tube like that which comes with the Flashforge Finder.
2. The MkII is more generic and is meant to be used without a tube. If you do not have an appropriate length guiding tube, use this one.
3. NEW! The MkIII is an updated version of the MkII with smoother bevel on each side. Note that the top bevel (facing the bed while printing) can become a little bit stringy when printing without supports. (I would still prefer to print it w/o supports and then file the artefacts away.)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
