Thingiverse
Filament pulley printertop
von Wired1
207
Downloads
156
Likes
4
Makes
Video here: http://youtu.be/bSbYbVXHCSA
Neat little two piece pulley and block so fit on top of an 8mm or 5/16" threaded rod, or screw it to the underside of a shelf above your printer.
The two pulley halves just fit together without the need for glue.
this is the best filament feed system I have come up with, it is very fast to change and lets you run multiple spools on a rack beside your printer http://www.thingiverse.com/thing:28944 or between them like I have done here.
Mine clips into the top rails of my Mendel Prusa via the mounting clamp I have used on other similar projects.
Neat little two piece pulley and block so fit on top of an 8mm or 5/16" threaded rod, or screw it to the underside of a shelf above your printer.
The two pulley halves just fit together without the need for glue.
this is the best filament feed system I have come up with, it is very fast to change and lets you run multiple spools on a rack beside your printer http://www.thingiverse.com/thing:28944 or between them like I have done here.
Mine clips into the top rails of my Mendel Prusa via the mounting clamp I have used on other similar projects.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
