Thingiverse
Filament rack/wall mount
por 3DPrintMunich
33
Descargas
23
Likes
0
Makes
Wall mount for filament rolls (1kg).
You need a 20mm pipe. In my case it's eloxed aliuminium.
The holes for the screws have 5,5mm.
I added a smaller version, too. --> Ending "_mittel". This for the same pipe size, but a bit smaller (Saving filament and printing time) for up to 6 rolls of filament.
The signs are also included.
It's recommended to print this rack in ABS. PLA might siplinter while screwing on.
You need a 20mm pipe. In my case it's eloxed aliuminium.
The holes for the screws have 5,5mm.
I added a smaller version, too. --> Ending "_mittel". This for the same pipe size, but a bit smaller (Saving filament and printing time) for up to 6 rolls of filament.
The signs are also included.
It's recommended to print this rack in ABS. PLA might siplinter while screwing on.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!