Filament Roll Count Tabs

Running out of filament mid-print is annoying. Running out of filament and realizing you don’t have a backup? Even worse. Boost MeIf you dig this model, throw me a Boost! The 3d gods will reward you. I like to keep extra rolls of my most-used filaments on hand, but tracking them was a pain. Spreadsheets? Never updated them. Mental notes? Useless. Walking to the garage every time I needed to check? Not happening. So I made these Filament Roll Count Tabs. They snap onto your filament roll, stay put when stored, and slide freely when in use. When the roll is empty, the tab just falls off—no extra steps. They print fast, require no supports, and snap together without fuss. Each piece is identical, so no need to figure out which side goes where. Designed to work while your filament is loaded in the AMS, they even help prevent that little black sticker from clogging things up. Just swap in a fresh roll, update the number, and Bob’s your uncle. I made numbers 1 through 9, so just copy and pas