Filament Roll Holder

This is a simple, skateboard bearing-based filament holder for your 3d printer. The two halves press-fit together and the bearings press-fit onto their pegs as shown in the photographs. This is made to be a permanent solution, so the two sides fit together quite snugly, and joining then will require significant force. A few light hammer taps may not be entirely out of place :) While not entirely necessary, 2 screws (#4-40, 3/8") provide extra long-lasting security.

*You'll need to print 2 of these for a functional set

Bearings: http://amzn.com/B002BBGTK6