Filament Runout Sensor Case - REMIX

Carries the same simple design, however adjusted for the roller switch to operate better without case/switch modifications.

15oct2019 Updates:
The following adjustments were made to support a RAMPS or similar board that has 3v3 to 5v pin available at/near an endstop/runout pin. This allows for an LED to be lit when there is no filament in the sensor.
1) Added a third version to have PTFE connectors at both ends
2) Adjusted threaded bosses from 5mm to 5.3mm in length for smaller profile CR-10/Ender 3 PTFE couplers
3) Created versions with hole for 3mm LED
4) Added Coordinate systems to cases so STL's will be flat w/o re-orientation in slicer
5) Added notches in all three covers for LED clearance
6) Adjusted slot for wire due to using a 3mm diameter, 2 conductor shielded security wire
7) Created additional instructions for wiring in a LED and a basic Klipper firmware config. (link below)

There is 3 different cases and 3 covers to choose from:
1) Standard Case w/wo 3mm LED