Thingiverse
Filament runout sensor ender
por davidcnns
1
Descargas
0
Likes
0
Makes
This part is a brace to use with the stock Z-end stop switch. This part requires the BLTouch upgrade kit.
Once the kit is installed, the Z end stop switch becomes useless. This part uses the spare switch as a filament runout sensor, no extra parts needed.
I have tested this part on an ender 5 pro. It would be appreciated if anyone with an ender 3 can verify this will also work.
Remember to update the marlin firmware and to set the correct pin for the switch:
#define FIL_RUNOUT_PIN Z_MIN_PIN
Once the kit is installed, the Z end stop switch becomes useless. This part uses the spare switch as a filament runout sensor, no extra parts needed.
I have tested this part on an ender 5 pro. It would be appreciated if anyone with an ender 3 can verify this will also work.
Remember to update the marlin firmware and to set the correct pin for the switch:
#define FIL_RUNOUT_PIN Z_MIN_PIN
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
