Thingiverse
Filament Runout Sensor w/ Limit Switch
by core2
41
Downloads
30
Likes
0
Makes
This is a remix.
v4: Version for v-slot and ptfe tube. For use with my "TBGS Extruder Mount". (use a M6 tube connector)
v3: After some testing I decided to realign the limit-switch and the bearing. Now the sensor works without the "ptfe holder" with even less friction.
v2: Thought it would be nice to have a cover. Also reworked the holes for the ptfe tubes.
Adopted the "spare out" to use this sensor with a higher variety of limit swichtes, cause of different solder joint. Also added smaler holes to insert two pieces of ptfe tube for more filament stability.
Cheers and thx to 3djpco for his great design!
1. For the cover use M2x5mm screws
2. To insert the ptfe tubes into the holes you dont need glue. Just a bit of pressure.
v4: Version for v-slot and ptfe tube. For use with my "TBGS Extruder Mount". (use a M6 tube connector)
v3: After some testing I decided to realign the limit-switch and the bearing. Now the sensor works without the "ptfe holder" with even less friction.
v2: Thought it would be nice to have a cover. Also reworked the holes for the ptfe tubes.
Adopted the "spare out" to use this sensor with a higher variety of limit swichtes, cause of different solder joint. Also added smaler holes to insert two pieces of ptfe tube for more filament stability.
Cheers and thx to 3djpco for his great design!
1. For the cover use M2x5mm screws
2. To insert the ptfe tubes into the holes you dont need glue. Just a bit of pressure.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
