Thingiverse
Filament Sensor Bracket - Flying Bear Ghost 5
von tcroonen
35
Downloads
25
Likes
0
Makes
Due to the filament inlet and the extruder drive are originally mounted on the backside of the printer I decided to rework this a little bit.
For me it is impractical to deal with the filament on the backside - so I pulled it to the front. To operate it from front side.
The extruder drive went up on top of the XY sled. And the filament sensor is now mounted on the left front side. With a hose to the top it is easy to change the filament now.
http://croonen.tech/3d-printing/flying-bear-ghost-5-upgrade/
For me it is impractical to deal with the filament on the backside - so I pulled it to the front. To operate it from front side.
The extruder drive went up on top of the XY sled. And the filament sensor is now mounted on the left front side. With a hose to the top it is easy to change the filament now.
http://croonen.tech/3d-printing/flying-bear-ghost-5-upgrade/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
