Thingiverse
Filament sensor
von denmx
15
Downloads
2
Likes
1
Makes
This item is detected if filament is end, conatcts is switch on.
You need 2 spring 5-6mm, 9mm long
2 metal sphere from bearing 6mm
2 M3 bolts.
Print it in 2 copyes.
Connect wire to spring and insert it inside. put sphere at spring and connect two part of this gadget by M3 bolts
You need 2 spring 5-6mm, 9mm long
2 metal sphere from bearing 6mm
2 M3 bolts.
Print it in 2 copyes.
Connect wire to spring and insert it inside. put sphere at spring and connect two part of this gadget by M3 bolts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
