Thingiverse
Filament Sharpener
door Zun3DP
8
Downloads
3
Likes
0
Makes
-come with plier to hold filament firmly.
-need knife-type pencil sharpener.
-cut the knife 5-6mm carefully to avoid injury. i just use 2 needle nose plier.
-recommend to use rough filament for better filament plier grip.
-don't use support.
-after print just snap the two part, plier and sharpener body.
-put some CA glue between knife and body.
NEW FIXED NOTE: fix orientation, plug secondary hole, smoothing some edge
-65 degree model required lower torque. Easier to twist.
-need knife-type pencil sharpener.
-cut the knife 5-6mm carefully to avoid injury. i just use 2 needle nose plier.
-recommend to use rough filament for better filament plier grip.
-don't use support.
-after print just snap the two part, plier and sharpener body.
-put some CA glue between knife and body.
NEW FIXED NOTE: fix orientation, plug secondary hole, smoothing some edge
-65 degree model required lower torque. Easier to twist.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
