Filament Spool Assembly

THIS PRINT REQUIRES BEARINGS TO BE FUNCTIONALI designed this as a filament spool holder that did not take room and allowed easy swapping of filament spools. The filament spool holder has a base measuring 5"x7", so it does not take up much space in the workstation. There are feet that push in to the base for better traction on the work surface. it elevates the platform approximately 0.25" from the surface. The spindles are designed to hold the spool in position and allow extruders to easily unwind the spool as needed. I designed the filament holder to use 8mmx22mmx7mm bearings (common skateboard bearings) with this print.I use PETG for the base and spindles, but you should be able to use PLA. I used TPU for the feet which are optional. The feet do fit tight into the base and may require a small flat screwdriver to install. Below are my recommended settingsBase (X1): infill 18%, no supports neededSpindles (X2): infill 35%, oriented standing up tall with standard supports on the bottom from the plate onlyTPU feet (X4): infill 15%, no supports needed