Filament Spool Bracket

I noticed that the HIC spool holder, while a nice addition is really too far away to be any good, too much filament spools out and then it gets twisted, and even pulled it off the shelf one night during a 7 hour print. So this one simply hangs off of the bridge and holds your spools there. The two end caps are cone shaped to fit a variety of spool centers. You will need about 8 inches of all thread, and it does block easy access to your SD car reader. i don't mind because i have mine hooked directly to my computer and don't really use the SD card reader. ( go Repetier)