Thingiverse
Filament spool cable reel
by machpavel
6
Downloads
13
Likes
0
Makes
Cable reel from an empty filament spool. Can be customized to match yours spool sizing.
It is intended to be used with screw-mounted cables, so it is possible to disassemble, run the cable through the design and assemble it again.
It consist of four parts:
- main thing to insert into the spool's center
- counted part to be screwed-in
- cable clip to fit the cable in place
- two optional handles for faster wind-up
I used PLA for start and had no problems with that since.
It is intended to be used with screw-mounted cables, so it is possible to disassemble, run the cable through the design and assemble it again.
It consist of four parts:
- main thing to insert into the spool's center
- counted part to be screwed-in
- cable clip to fit the cable in place
- two optional handles for faster wind-up
I used PLA for start and had no problems with that since.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!