Filament Spool Clips for Ethernet

A clip designed specifically for empty filament spools that latches onto the OEM cutouts on the side. Can hold most cables between 5mm and 6mm in diameter. The gap between the center wall and the cable arm is about 4.5mm so any cables smaller in diameter may fall out. My photos show a 100ft ethernet cable neatly wrapped and held with the clip, and a shorter 25ft cable. Be careful when installing the clip as the edges are sharp. It has a tight tolerance to ensure the clip does not come loose so you may need a bit of force. Included are clips designed specifically for these brands: HiPi / PiShop (batches as of 2026) Creality (batches as of 2026) Hello3D (batches as of 2022) These can be printed at 0.2mm layer height with literally any infill, as it is too small for any kind of infill. It took about 15m to print on my A1 mini (with all the pre-print calibrations). The corners/edges need to be precise so consider slowing down the print if needed.