Thingiverse
Filament spool holder and guide
by outsider
26
Downloads
11
Likes
2
Makes
Two discrete parts. One to hold a wider variety of spools, and another to act as the guide for the filament for the PP3DP UP! Plus printer.
The spool holder that comes with the printer only takes the narrow spools that PP3DP sells.
The spool holder I've created will allow for a 100mm wide spool and 250mm diameter spool to fit on the printer.
Also, since the spool holder gets replaced, a new filament guide was needed.
Both parts are heavy duty, and should last.
The spool holder that comes with the printer only takes the narrow spools that PP3DP sells.
The spool holder I've created will allow for a 100mm wide spool and 250mm diameter spool to fit on the printer.
Also, since the spool holder gets replaced, a new filament guide was needed.
Both parts are heavy duty, and should last.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
