Thingiverse
Filament spool holder
door juewei
4
Downloads
5
Likes
0
Makes
This Filament holder comes in two parts.
a) 3D-printed mount that comes in two parts. Both have a flange and a tube section andgently slide on each other, to change spool and accomodate different spool widths.
b) lasercut legs to stand the spool on a table.
the 3D-Printed mount has a hook at the back of the flange so that it can be mounted on a 3mm acrylic edge, if you have that on top of your 3D Printer housing somewhere. Works well for a tinyboy fabricator - if the spool is sufficiently light. Otherwise it jams against the back of the housing or the entire printer may tumble over.
For these cases you need the legs.
Maximum spool dimensions:
- Diameter 225mm diameter with 68mm hole.
- Width 110mm.
Cat not included.
inspired by http://www.thingiverse.com/thing:957550
a) 3D-printed mount that comes in two parts. Both have a flange and a tube section andgently slide on each other, to change spool and accomodate different spool widths.
b) lasercut legs to stand the spool on a table.
the 3D-Printed mount has a hook at the back of the flange so that it can be mounted on a 3mm acrylic edge, if you have that on top of your 3D Printer housing somewhere. Works well for a tinyboy fabricator - if the spool is sufficiently light. Otherwise it jams against the back of the housing or the entire printer may tumble over.
For these cases you need the legs.
Maximum spool dimensions:
- Diameter 225mm diameter with 68mm hole.
- Width 110mm.
Cat not included.
inspired by http://www.thingiverse.com/thing:957550
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
