Thingiverse
Filament spool holder
von xile6
3
Downloads
0
Likes
0
Makes
Simple spool holder.
Uses 8mm smooth or threaded rod.
608 bearings. (4x per spool)
Print 2 ends, then 4 guides per spool, and 1 or 2 spacer to separate the spools.
the 60mm spacer is to go in between the bearing so they dont slide around.
Uses 8mm smooth or threaded rod.
608 bearings. (4x per spool)
Print 2 ends, then 4 guides per spool, and 1 or 2 spacer to separate the spools.
the 60mm spacer is to go in between the bearing so they dont slide around.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!