Thingiverse
Filament Spool Holder
door Plastic_Diamond
2
Downloads
0
Likes
0
Makes
Made a filament spool, pretty simple to print since its just one part
I would recommend using tree branch supports and a layer height of 0.28mm
I would also say to scale it up in your slicer by maybe 5 or 10 percent to make sure it comfortably fits your spools.
I used a wall count of 3 and cubic infill (10%) and it printed very fast and easy
I would recommend using tree branch supports and a layer height of 0.28mm
I would also say to scale it up in your slicer by maybe 5 or 10 percent to make sure it comfortably fits your spools.
I used a wall count of 3 and cubic infill (10%) and it printed very fast and easy
Plastic_Diamond publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
