Thingiverse
Filament Spool holder - Universal
door 3BeePrinting
4
Downloads
2
Likes
0
Makes
Designed this filament spool for the PRUSA Lack table enclosure. However the design is universal and can be mounted on any surface. You can easily slide the rod in the holders and start printing!
If you use an Ikea Lack table, you can use 8x M4x60mm bolts to bolt it to the top surface of the table. For other surfaces, use M4 bolts as well.
Printing:
- PLA is fine, using standard settings (0.2 layer height etc);
- The Rod Stoppers mounted on the end of the ROD are tight fit. If you experience that its a too tight fit, I recommend increasing the scale of the Rod Stoppers slightly (can be done in any slicing software)
If you want to help you design or print your own cool project, check out our website:
https://www.3beeprinting.com/
If you use an Ikea Lack table, you can use 8x M4x60mm bolts to bolt it to the top surface of the table. For other surfaces, use M4 bolts as well.
Printing:
- PLA is fine, using standard settings (0.2 layer height etc);
- The Rod Stoppers mounted on the end of the ROD are tight fit. If you experience that its a too tight fit, I recommend increasing the scale of the Rod Stoppers slightly (can be done in any slicing software)
If you want to help you design or print your own cool project, check out our website:
https://www.3beeprinting.com/
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
