Filament Spool Holder - V1

🎉 Update: Check out the new and improved version! Filament spool holder with bearing rollers. Supports spool sizes up to 70mm wide. Push-fit assembly, no glue required. Perhaps a bit over-engineered but it's fun to fit together and it works well. Some of the tolerances can be quite tight so in the case of a tight fit between parts the inner surfaces (not visible in the final model) can be lightly sanded to obtain a snug fit. Requires 4x 608 bearings (printed bearings work too!) Use rubber feet to prevent sliding on smooth surfaces. Note that when not using the print profile, multiple pieces of certain components are needed:1x Frame2x Roller Outer Casing4x Roller End Cap4x Roller Inner2x Axle4x Bearing Shim4x Axle Pin