Filament Spool Holder V2

This is a complete filament spool holder. You can use this to hang a spool from a metal pipe or clothes pole. While the intent was to reduce friction on the spool and let it turn more easily than the factory supplied one, I may have over done it a little.

Print HangerL, HangerR, ConnectorM, and 2 SpoolEnd. They will snap together and look like the picture.

The OpenSCAD file in included. The code is crude but you can change the parameters to fit other pole or spool sizes. If the spool spins too easily you can increate the pin and hole diameters.

I suggest using a fill density of 50% or setting the width up by a mm. I will be posting a refined scad program when I have time to clean it up.