Thingiverse
Filament Spool Keeper
door PeteTheShopper
2
Downloads
1
Likes
0
Makes
This is a 30mm od retainer with a slide into place keeper. Over 50mm id spool will fit without doing anything; just slide it on.. Under 50mm down to 30mm requires loosening the 30mm retainer 7mm and then sliding out the keeper, then after sliding on the spool; replacing the keeper. Sounds more complicated than it is.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
