Filament/Spool Rack Pole End Cap

Pole End Caps for Filament Storage RackI love my filament storage rack from Brownbear. However, I am using it with relatively short 90cm poles. These poles need an end cap so they don't easily slide out. This print contains a set of four pole end caps needed for a single layer of the rack.The pole end caps are compatible with both v1 and v2 of the rack system and provide the following benefits:Outside fillet matches the v2 level connector designOnly 5mm insert into rack hole28mm diameter at the back, ensuring that structural weight remains on the pole4mm screw hole fitting the head of a SPAX 4x25 wood screwUsePrint a set of 4 for each rack layerUse a nail or something similar to mark the center of the hole on both sides of a poleDrill a 3mm hole into both sides on the pole (about 15mm deep)Use SPAX 4x25 screw to fasten a pole end cap on one sideInsert into the rack and fasten pole end cap on the other sideFilament15.26g of PLA Matte filament per set of 4 (Bambu Lab 11100 PLA Matte