Thingiverse
Filament Spool Rack
von srah1
39
Downloads
27
Likes
1
Makes
This is a filament spool rack made of wooden rod (15mm thick)
- Cut the rod into 3 lengths as long as you'd like your rack to be wide.
- Cut the remaining rod into 4 shorter peices, minimum 14cm
- Print 4x corner brackets
- Print 2x rail holder brackets
Use a wood glue, like Gorilla Glue to glue the rod into the brackets.
Check out the instructable at http://www.instructables.com/id/Filament-Spool-Rack/ which explains how to make it
- Cut the rod into 3 lengths as long as you'd like your rack to be wide.
- Cut the remaining rod into 4 shorter peices, minimum 14cm
- Print 4x corner brackets
- Print 2x rail holder brackets
Use a wood glue, like Gorilla Glue to glue the rod into the brackets.
Check out the instructable at http://www.instructables.com/id/Filament-Spool-Rack/ which explains how to make it
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
