Thingiverse
Filament Spool Spacer
von Klaukralle
2
Downloads
1
Likes
0
Makes
Very simple star spacer between filament spools.
My spools are on a 32mm aluminium pipe in a dry box and i wanted a simple spacer (1cm Z) between the spools. Its size is about 80mm(X and Y). The star spikes are long enough that the spacer wont be able to slip into the spool. Inner diameter is approx. 33mm so that it fits pretty exactly on the pipe.
Printing time is approx 50 minutes and uses around 3,5 metres of filament.
My spools are on a 32mm aluminium pipe in a dry box and i wanted a simple spacer (1cm Z) between the spools. Its size is about 80mm(X and Y). The star spikes are long enough that the spacer wont be able to slip into the spool. Inner diameter is approx. 33mm so that it fits pretty exactly on the pipe.
Printing time is approx 50 minutes and uses around 3,5 metres of filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
