Thingiverse
Filament spool twist
von Baird_Design
91
Downloads
67
Likes
1
Makes
Twist Filament Holder
Designed for printing in ABS
All my prints were made with layer height .15mm with no supports
Threads on center lock are reversed to prevent losing on machine (designed for the spool holder on the back of the Flashforge pro 2016 above the switch). All my prints were completed with no supports, there are some overhangs that could use them but I shall leave that to you.
Two of the file are meant to be used together in one dual extrusion print. Plate w logo.stl and logo and washer.stl see photo.
Print 8x plate W logo
print 4x Filament guide
Filament guide hole is sized for #4 X 5/8 screws and a metal washer.
Designed for printing in ABS
All my prints were made with layer height .15mm with no supports
Threads on center lock are reversed to prevent losing on machine (designed for the spool holder on the back of the Flashforge pro 2016 above the switch). All my prints were completed with no supports, there are some overhangs that could use them but I shall leave that to you.
Two of the file are meant to be used together in one dual extrusion print. Plate w logo.stl and logo and washer.stl see photo.
Print 8x plate W logo
print 4x Filament guide
Filament guide hole is sized for #4 X 5/8 screws and a metal washer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
