Filament Spool Wall Holder

This simple spool holder requires a bar or pipe that goes inbetween the two printed parts.

The dimension of the gap for the bar/pipe is 30mm in diameter. I use an aluminium pipe with 25mm diameter with it. Scale the part up if you plan to use it with a larger bar/pipe. I recommend a metal pipe to reduce friction on the spools.

I use a pipe of 500mm length, which will fit about 4-6 1kg spools comfortably. I haven't tested longer pipes / more weight. Please be careful when putting lots of load on the parts!

The part corresponds to the right wall holder part.
Mirror & flip by 180 degrees in your slicer to get the left one.

The screw holes are 5mm in diameter. I use slightly thinner, but fairly long, screws with it.

The part is 190x210x40mm in size.