Thingiverse
Filament Spool Wall Mount
von Stephen_J
94
Downloads
69
Likes
1
Makes
Filament spool wall mount. Holds spools up to 69mm in width, with hub holes 31mm or larger. Has four holes for mounting, with 3mm diameters, so small self taping screws will work just fine. Shoot for a screw that's at least 15mm-20mm in length.
Print with base side down. All angles are 45 degrees so support shouldn't be needed.
Print with base side down. All angles are 45 degrees so support shouldn't be needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
