Thingiverse
Filament Spool Washer
von jbolonski
3
Downloads
2
Likes
0
Makes
Some of my filament spools had very large openings and I want to make sure they wouldn't slide off the holder and jam the printer.
In the photograph is shown with a Tension Nut ( http://www.thingiverse.com/thing:116872 ) in place.
In the photograph is shown with a Tension Nut ( http://www.thingiverse.com/thing:116872 ) in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!