Thingiverse
Filament spool with indicator
por Lex178
5
Descargas
3
Likes
0
Makes
Not exactly my design, but I couldn't find the original.
This is a slightly reinforced version of the coil with an indicator of the remaining plastic(100-400 meters). You can use 2 or 4 M5*65 screws for Assembly. It can be used on bearings or with a bushing (see my designs).
Printing each half takes about 4-6 hours and requires about 35 meters of plastic.
Sources are attached. Modeled in Autodesk Inventor.
Edited 22.10.2020. Increased the diameter of the m5 screw holes from 5.5 to 6.1mm
This is a slightly reinforced version of the coil with an indicator of the remaining plastic(100-400 meters). You can use 2 or 4 M5*65 screws for Assembly. It can be used on bearings or with a bushing (see my designs).
Printing each half takes about 4-6 hours and requires about 35 meters of plastic.
Sources are attached. Modeled in Autodesk Inventor.
Edited 22.10.2020. Increased the diameter of the m5 screw holes from 5.5 to 6.1mm
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
