Thingiverse
Filament Stand
por Mauritsio
8
Descargas
4
Likes
0
Makes
This is a lavish looking filament spool holder for up to two rolls of filament.
Take two ca. 20 centimeter smooth rods (8mm) and 13x22 cm base plate (I used a 18mm thick MDF-plate, which gives a solid stand).
The top part is easy to take off, to change the rolls. The feet fit very tightly, so the rods don't fall out.
Tip: You can use leftovers from cutting smooth rods when building a 3D-printer, as the exact height doesn't actually matter and its a shame to throw them away.
EDIT: PLA is totally fine for this, no need start a hassel with ABS oder PETG etc.
Take two ca. 20 centimeter smooth rods (8mm) and 13x22 cm base plate (I used a 18mm thick MDF-plate, which gives a solid stand).
The top part is easy to take off, to change the rolls. The feet fit very tightly, so the rods don't fall out.
Tip: You can use leftovers from cutting smooth rods when building a 3D-printer, as the exact height doesn't actually matter and its a shame to throw them away.
EDIT: PLA is totally fine for this, no need start a hassel with ABS oder PETG etc.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
