Filament Storage Cabinet

Update: Wow - its been close to a year since I posted this! The build has taken longer than I had hoped, due other responsibilities but its coming along nicely. I have attached some photos showing its current state, as well as photos of the hinges in use. The door is offset from the cabinet to allow room for a 3/8" weather seal, as well as allowing the outer edge of the door to swing “in”, so it will not need additional room on the side of the cabinet with a normal, outside hinge such as your refrigerator door. You'll notice I have a second set of rods in the back of the left side to support the filament - this was due to a manufacturing flaw - I was so focused on accounting for the largest spool I had, I forgot to account for the tray I wanted to go under each set of rods. As a result the smaller set of spools would sit just low enough to cause an issue. I printed some adapters to add to the top of the existing ones, and added a rod there. This in effected reduced the distance, raisin