Thingiverse
Filament Storage Drybox small
door SirPandaNerd
1
Downloads
1
Likes
0
Makes
Filament storage box small.
Need a small form factor for some small spools of filament, a spool diameter of 200mm.
The top fits on top of the bottom. It holds but is not too tight to open. I printed in PLA, so not completely airtight, but a desiccant pack should keep the filament dry.
Has a slot in the front to hold a filament sample and such.
Printer setting, .04mm nozzle, .2mm layer height, 210c temp, bed 60c, 50 speed, brim (prevent warping)
The filament used GST3D PLA+: https://fremover.net/.../gst3d-pla/products/pack-x10-pla...
You can get spools of filament for around $10 when you get the 10 pack, and it is good filament comparable to popular brands. And yes I get a few nickels if you use the above link.
Printer used an Anycubic Vyper.
Need a small form factor for some small spools of filament, a spool diameter of 200mm.
The top fits on top of the bottom. It holds but is not too tight to open. I printed in PLA, so not completely airtight, but a desiccant pack should keep the filament dry.
Has a slot in the front to hold a filament sample and such.
Printer setting, .04mm nozzle, .2mm layer height, 210c temp, bed 60c, 50 speed, brim (prevent warping)
The filament used GST3D PLA+: https://fremover.net/.../gst3d-pla/products/pack-x10-pla...
You can get spools of filament for around $10 when you get the 10 pack, and it is good filament comparable to popular brands. And yes I get a few nickels if you use the above link.
Printer used an Anycubic Vyper.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
