Thingiverse
Filament Swatch
por Trickonomy
5
Descargas
9
Likes
0
Makes
This is a Filament swatch, so you can look at all your filaments before deciding wich you want to use.
!! Print with 100% infill !!
The steps are to See the transparency at different heights. The steps are 0,5mm, 1mm, 1,5mm and 2mm. The rest of the body is 2,5mm thick.
There are also small overhang test. The distances are 5mm, 7,5mm, 10mm and 12,5mm. Obviously they could have been larger, but i wanted to keep the swab small.
There is also a Chamfer test. The Chamfers go from 30 degrees to 45 degrees.
!! Print with 100% infill !!
The steps are to See the transparency at different heights. The steps are 0,5mm, 1mm, 1,5mm and 2mm. The rest of the body is 2,5mm thick.
There are also small overhang test. The distances are 5mm, 7,5mm, 10mm and 12,5mm. Obviously they could have been larger, but i wanted to keep the swab small.
There is also a Chamfer test. The Chamfers go from 30 degrees to 45 degrees.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
