Thingiverse
Filamentholder
por Eber
9
Descargas
7
Likes
0
Makes
This is a simple filament holder without bearings.
Print 2x pinne
Cut a wooden stick that fits inside the tube a bit longer than 80mm. I used a bbq skewer.
The wooden stick is possible to put inside the holes after the print of filamentholder3 if printed in pla, otherwise pause the print after 18.5mm put in the sticks and resume.
Use some sandpaper and lubricate the stick if you want it to spin some more.
Print 2x pinne
Cut a wooden stick that fits inside the tube a bit longer than 80mm. I used a bbq skewer.
The wooden stick is possible to put inside the holes after the print of filamentholder3 if printed in pla, otherwise pause the print after 18.5mm put in the sticks and resume.
Use some sandpaper and lubricate the stick if you want it to spin some more.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
