Thingiverse
Filamentlager
door hooca
7
Downloads
3
Likes
0
Makes
Mounting braket with two ball-bearings for a filament-roll for a Monoprice Mini Delta.
You need two of these brakets and four ball-bearings with bore 3mm, outer diameter 10mm and width 4mm.
Two of these brackets can be clipped to the filament-holder beam of a Monoprice Mini Delta, adjusted in distance and then carry a filemant-roll with low friction.
Can be printed on a properly calibrated Monoprice Mini Delta itself
You need two of these brakets and four ball-bearings with bore 3mm, outer diameter 10mm and width 4mm.
Two of these brackets can be clipped to the filament-holder beam of a Monoprice Mini Delta, adjusted in distance and then carry a filemant-roll with low friction.
Can be printed on a properly calibrated Monoprice Mini Delta itself
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
