FilletEdge5-12

This is a redesign of https://www.thingiverse.com/thing:5588493. I wanted to give the top part a flat bottom, but there was no way to print this without making the legs ridiculously large. SO instead I opted to make it in 2 parts: the top, and the bottom.

The top is a regular bowl shape that printed in 15 1/3 hours and can be printed and used by itself. The bottom, 5 twisted legs, printed in a little less than 6 hours. Due to the shallow slope of the legs I specified Fuzzy Skin in SuperSlicer's settings. This works well to hide the rough surfaces on the bottom sides of the legs that result from their shallow slope.

Both parts printed at 100 mm/sec and layer height of 0.200 mm. So - how to connect the 2? The method I use is not to try to glue them together. Instead I weld them by using a solvent that melts the PLA and fuses it together. The solvent disappears (it is extremely volatile) and though it may look like there are 2 parts, in reality they are fused into a single one. So -