Fimi X8 range booster

True parabolic range boosters for the Fimi X8 SE drone.

Print two of each of the STL files to make two boosters, one for each antenna. Use enough perimeters that you don't get any infill in the vertical wall

You also need a metallic reflecting surface, and for that you need a soda/beer aluminium can. Take the can and cut out a piece of the wall that is 85 mm high and around 95 mm wide. Make sure it is cut straight, because if it is crooked, it will not mount properly to the booster and will probably buckle).

Start by cutting out a piece that is a bit too large, then carefully press it flat on a cutting surface, and mark where to cut. The aluminium is thin enough that scissors are perfectly fine to cut/trim it with. It will spring back into shape even if pressed against the table for marking (or cutting).

The cutout should slide down from the top (but you will of course need to bend it outwards to do so, since the can has a smaller radius than the booster) into the grooves o