FInger Gauntlet

This is a Finger Gauntlet designed specifically for a full hand but I isolated the finger and am using that for this submission. I like to print the parts from PLA or PETG at 100% infill for a nice and solid weighty feel. but preferences may very. I recommend 0.1mm layer height if possible to increase detail and to help tolerances fit better. You must print all fie parts, and they snap together as shown in the image. I'm sorry to not be able to provide 3mf files or print profiles. or assembly instructions due to my laptop being broken so I cannot run Bambu studio and such, but no additional hardware is required for assembly. I hope the design is intuitive enough for you all to figure out and reach out with any questions or issues about it.