Thingiverse
Finger Trap Keychain
von lambo131
15
Downloads
7
Likes
0
Makes
This is a cool mini bear trap you can put on your keychain! All components can be printed at once with a good arrangement.
You need a torsion sprint, the one I used was 0.7mm, 6 rotations, 4mm outer diameter. You may also need a utility blade and some sand paper. If you want to color it, you can buy oil makers.
You need a torsion sprint, the one I used was 0.7mm, 6 rotations, 4mm outer diameter. You may also need a utility blade and some sand paper. If you want to color it, you can buy oil makers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
