Thingiverse
Fingerboard Mold
von TheMan1095
6
Downloads
16
Likes
0
Makes
This is my design, so if the allignment pins are too big, just sand them down a bit. This mold makes a 92mm board with 30 degree kicks and no flat spots. The mold is 30mm wide. Also check out my tinkercad page. Cheers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!