Fingerboard Quarter Pipe

This is another fingerboard obstacle to add to my sons collection and it's the largest yet! This is a large quarter pipe and it measures 300mm(l) x 245mm(w) x 190mm(h). I’ve added a brick pattern on the base to give it a more realistic look and feel. I usually print all our ramps in red marble filament, but due to the size of the ramp I used PLA Matte Terracotta to make it a more affordable option and it's worked really well in imitating bricks. The two tone grey on the concrete part was not intentional, but I ran out of my usual grey and had to switch over to another colour during the print. It has been designed in two pieces that will need to be glued together once printed. Once assembled, we added four small pieces of thin foam fingerboard grip tape on the base to prevent it from sliding around when skating on it. If you like this model check out our other fingerboard models. https://makerworld.com/en/models/2222949-fingerboard-curved-concrete-block-rail#profileId-2533017 https://makerworld.com/en/models/2214065-fingerboard-ramp-with-concrete-parking-block#profileId-2407096 As always, I'd love to see pictures of your prints.