Thingiverse
Fingerbone Windchime
door DaveMakesStuff
3.5k
Downloads
2.5k
Likes
4
Makes
NOTE: This model has been updated and is available here: https://social.thangs.com/m/391916
These print-in-place fingerbone chains can be used as windchimes, beaded curtains, keychains or whatever other haunted decoration ideas you might have!
See here for video: https://youtu.be/o14t0UBf09c
All five fingers are provided to accommodate different build plate sizes and allow for a variety of fingerbone-chain lengths in your final project. Lengths include: Thumb (112mm), Pointer (161mm), Middle (168mm), Ring (159mm) and Pinky (139mm).
These fingerbone chains are connected using a unique print-in-place ball-and-socket joint allowing the finished print to fully turn, twist, and rotate. Bones are full sized, but have been altered slightly to allow for addition of the ball and socket joints.
Windchime holders are provided in two sizes, 10-prong and 12-prong. Thread three short, knotted lengths of string through the three outer holes in the windchime holder, then knot the three
These print-in-place fingerbone chains can be used as windchimes, beaded curtains, keychains or whatever other haunted decoration ideas you might have!
See here for video: https://youtu.be/o14t0UBf09c
All five fingers are provided to accommodate different build plate sizes and allow for a variety of fingerbone-chain lengths in your final project. Lengths include: Thumb (112mm), Pointer (161mm), Middle (168mm), Ring (159mm) and Pinky (139mm).
These fingerbone chains are connected using a unique print-in-place ball-and-socket joint allowing the finished print to fully turn, twist, and rotate. Bones are full sized, but have been altered slightly to allow for addition of the ball and socket joints.
Windchime holders are provided in two sizes, 10-prong and 12-prong. Thread three short, knotted lengths of string through the three outer holes in the windchime holder, then knot the three
DaveMakesStuff publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
