Slicer Discord
Fire tablet Wall storage – 3D printable model from MakerWorld MakerWorld
Decor

Fire tablet Wall storage

1 Downloads
0 Likes
0 Makes
Go to Model
My wife as a itty-bitty side table next to the sofa that often becomes over burdened with a cup of coffee a tablet, phone, and possibly a kindle fire. After a couple spills and near misses with the tablet i decided to create a wall holder for her electronics to get them off the table. It can hold an 11 inch fire tablet, a phone with a reasonable case (my pixel with otterbox fits) a kindle paperwhite and some pens. I added a couple holes for charging the tablet and phone. I am however not totally sure of the phone charging cable hole, I may change it later, it is a problematic to keep the cable in if not plugged up. My profile is printed with 4 line and a reasonable infill. I would not suggest dropping the number of walls, all the stuff you can put in this organizer gets pretty heavy quickly. I also suggest you attach to a stud or use good drywall anchors if putting in drywall. As a side note i took our logo off of this print, so its exactly the same without the heart logo.
Category
Decor
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection