FireBoard Spark Case

I present to you a handy storage case to protect your Fireboard Spark when not in use. This case does not require any supports and uses 8ea. 6mm x 2mm neodymium magnets to keep the case shut.

I suggest using PETG, however PLA or any other material will work fine. Due to PETG’s low bridging capabilities, you can orient the layer covering for the fire logo in such a manger to add texture within the flames. Maybe even print with a color layer change for additional effect. If you do, please post a “make”!

Enjoy!

.04 Nozzle
.20 Layer Height
25% infill (could go less with PLA)
No Supports

Magnets vary in size, but a dab of glue will hold them in nicely. I recommend Beacon 3-in-1 over superglue.

Important, get the polarity of the magnets on the top and bottom case correct before gluing them in so that they attract and not repel each other.