Thingiverse
FireStick 4K Sleeve Revised
door 8bitz
15
Downloads
6
Likes
0
Makes
printed in Sunlu PETG.
Held on to remote by tension.
Recommend printing at 98 percent scale.
Tree supports everywhere recommended.
Below settings were used in Cura:
- Print Speed 65 mm/s
- Cooling - Fans Off
- Tree Supports = On (Everywhere)
- Build Plate Adhesion = Brim
- Scale = 98% (original print @ 95% had issues with layer adhesion)
Held on to remote by tension.
Recommend printing at 98 percent scale.
Tree supports everywhere recommended.
Below settings were used in Cura:
- Print Speed 65 mm/s
- Cooling - Fans Off
- Tree Supports = On (Everywhere)
- Build Plate Adhesion = Brim
- Scale = 98% (original print @ 95% had issues with layer adhesion)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
