MakerOnline
3D Printer
Go to Model
First Layer Calibration Test
1.9k
Downloads
132
Likes
0
Makes
Test your 3d printer bed level! Easy to print model made to test the first layer adhesion. No need to waste filament by printing the whole plate when the most used part is in the middle of the plate! Print a 60x60mm square in the middle of the plate and verify your printer accuracy with different filaments
Hanti_3d also publishes on
11 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
