Thingiverse
fischertechnik MPU6050 movement sensor
von juh
4
Downloads
2
Likes
0
Makes
This is a case for the MPU6050 GY521 gyroscope/accelerometer module with fischertechnik connectors.
The 2x6 I2C pin connector is pin compatible with ftDuino and fischertechnik TX connectors. See the pictures for assembly details. A lightguide for the module's LED is optional, just drill or push the hole in the top part fully through and insert a short length of transparent 1.75mm filament.
If you like my design, please leave a comment, upload a make, or favorite it.
__Materials and methods__
6x2 pin header
2x7 strip of perfboard
a couple of wires
8mm piece of transparent filament (optional)
Previously published at [Youmagine](https://www.youmagine.com/designs/fischertechnik-mpu6050-movement-sensor)
The 2x6 I2C pin connector is pin compatible with ftDuino and fischertechnik TX connectors. See the pictures for assembly details. A lightguide for the module's LED is optional, just drill or push the hole in the top part fully through and insert a short length of transparent 1.75mm filament.
If you like my design, please leave a comment, upload a make, or favorite it.
__Materials and methods__
6x2 pin header
2x7 strip of perfboard
a couple of wires
8mm piece of transparent filament (optional)
Previously published at [Youmagine](https://www.youmagine.com/designs/fischertechnik-mpu6050-movement-sensor)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
