Fish Feeder Ring: Horizontal Clamp

Thank you to gwhitt856 for the original model! This remix features a horizontal clamp + a shorter ring length for the purposes of fitting in a ¼" plexiglass hole (see images). We needed the lid on this tank to sit flush to prevent jumping fish from having their way! The original model would collide with the lid when closed since it was designed to clamp over the other edge. If you use a similar setup, the shorter ring length should allow you to get food through the hole and into the ring without contorting your fingers too much. Oh, and the height of the holder was extended as well just in case your water levels vary more. PETG recommended (over PLA) for better durability when used long term in water.